Quick Contact: 800-254-8665
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
 |  |  |  |  |  |
The Bend-it is a bender that was specifically designed to bend automotive exhaust and tail
pipes. These sizes are typically 1 ½” - 3.0” in outside diameter. The typical center line radius that
the Bend-It utilizes is 1.75D. The typical muffler shop manual bender can only bend 2D before
wrinkling or excessive marking occurs. A big advantage that this tighter radius bending capability
will provide is more flexibility with the routing of the pipe. THE QUALITY OF THE BENDS
THAT ARE PRODUCED IS EXCEPTIONAL. The Bend-It also does an outstanding job bending
stainless tubing.
The new control that was designed specifically for the Bend-It utilizes state of the art
electronics. It incorporates a self-diagnostic program to test practically every portion of the
machine.
There are approximately 1,000 preprogrammed part numbers available for purchase. They are
categorized by Walker’s part numbers. The machine is also programmable. The control will
accept Bend Data Card format. The control also has a design mode for copies existing pipes.
The operation of the machine is very easy to learn. A new operator should be able to operate
the bender with just a few hours of training. Optional tooling is available.
pipes. These sizes are typically 1 ½” - 3.0” in outside diameter. The typical center line radius that
the Bend-It utilizes is 1.75D. The typical muffler shop manual bender can only bend 2D before
wrinkling or excessive marking occurs. A big advantage that this tighter radius bending capability
will provide is more flexibility with the routing of the pipe. THE QUALITY OF THE BENDS
THAT ARE PRODUCED IS EXCEPTIONAL. The Bend-It also does an outstanding job bending
stainless tubing.
The new control that was designed specifically for the Bend-It utilizes state of the art
electronics. It incorporates a self-diagnostic program to test practically every portion of the
machine.
There are approximately 1,000 preprogrammed part numbers available for purchase. They are
categorized by Walker’s part numbers. The machine is also programmable. The control will
accept Bend Data Card format. The control also has a design mode for copies existing pipes.
The operation of the machine is very easy to learn. A new operator should be able to operate
the bender with just a few hours of training. Optional tooling is available.